Skip to content
Start a project

CNC textures / Scallop

Sheet T32Water-carved stone$20

Scallop Water-carved stone

Overlapping scoops that fast water wears into cave walls and river rock, each with a steep lip upstream and a long shallow tail, all leaning the same way.

Scallop CNC carving texture rendered in walnut, seen at an angle
Rendered in walnut, low raking light
Scallop texture seen from directly above
Plan view, straight down
Relief0.200 in
Panel24 × 48 in
TilesBoth ways
Price$20
Buy on Etsy · $20 →

Also in Texture Pack 07, four textures for $59.

In the download

What you get

  • Full 24 × 48 in panel as a watertight STL, in inches
  • 16-bit grayscale heightmaps at 25 and 50 px/in
  • 12 × 12 in test tile, STL and PNG
  • One-page cut sheet PDF with bit, settings and steps
  • Works in Vectric Aspire, VCarve Pro, Carveco, Fusion 360 and Carbide Create Pro
  • Licence to sell what you carve (not the files)
Cut sheet

How to cut it

  1. Cut the 12 × 12 in test tile on scrap first.
  2. Face the stock flat and zero Z on the top surface.
  3. Import the STL or the 50 px/in heightmap at 24 × 48 in, 0.200 in deep.
  4. Rough with a 1/4 in flat end mill, leaving 0.020 in of stock.
  5. Finish with a 1/4 in ball nose at 0.020 in stepover, raster along the 48 in length.
  6. Panels larger than 24 × 48 in: tile the file edge to edge; it repeats without a seam.
  7. Knock off fuzz with a nylon brush or 320 grit, then finish as normal.

Feeds and speeds on the cut sheet are calculated starting points. Run the test tile first and adjust for your machine.

Also in Pack 07
Sea foam textureSea foamPacked bubblesCurrent textureCurrentFlowing ridgesDrape textureDrapeHeavy silk folds

All 33 textures →

Let’s build something permanent.

Tell us about the room and what it needs to do. We work in and around Jacksonville, Florida.

Start a project →

Built-ins, cabinetry and architectural woodwork, made by hand in Jacksonville, Florida.

Studio

Shop

Contact

© 2026 Roxford Carpentry30.33° N, 81.66° W