Skip to content
Start a project

CNC textures / Sastrugi

Sheet T10Wind-carved snow$24

Sastrugi Wind-carved snow

Long overlapping scoops with crisp crests, like snow ridges shaped by the wind.

Sastrugi CNC carving texture rendered in walnut, seen at an angle
Rendered in walnut, low raking light
Sastrugi texture seen from directly above
Plan view, straight down
Relief0.199 in
Panel24 × 48 in
TilesBoth ways
Price$24
Buy on Etsy · $24 →

Also in Texture Pack 02, four textures for $59.

In the download

What you get

  • Full 24 × 48 in panel as a watertight STL, in inches
  • 16-bit grayscale heightmaps at 25 and 50 px/in
  • 12 × 12 in test tile, STL and PNG
  • One-page cut sheet PDF with bit, settings and steps
  • Works in Vectric Aspire, VCarve Pro, Carveco, Fusion 360 and Carbide Create Pro
  • Licence to sell what you carve (not the files)
Cut sheet

How to cut it

  1. Cut the 12 × 12 in test tile on scrap first.
  2. Face the stock flat and zero Z on the top surface.
  3. Import the STL or the 50 px/in heightmap at 24 × 48 in, 0.199 in deep.
  4. Rough with a 1/4 in flat end mill, leaving 0.020 in of stock.
  5. Finish with a 1/2 in ball nose at 0.030 in stepover, raster along the 48 in length, with the wind lines.
  6. Panels larger than 24 × 48 in: tile the file edge to edge; it repeats without a seam.
  7. Knock off fuzz with a nylon brush or 320 grit, then finish as normal.

Feeds and speeds on the cut sheet are calculated starting points. Run the test tile first and adjust for your machine.

Also in Pack 02
Seigaiha textureSeigaihaJapanese wave patternCoral textureCoralBrain coralTakyr textureTakyrCracked clay flat

All 33 textures →

Let’s build something permanent.

Tell us about the room and what it needs to do. We work in and around Jacksonville, Florida.

Start a project →

Built-ins, cabinetry and architectural woodwork, made by hand in Jacksonville, Florida.

Studio

Shop

Contact

© 2026 Roxford Carpentry30.33° N, 81.66° W